Ultimaker Nozzle for use with Olsson Block 0.6mm

  • RS庫存編號 110-1984
  • 製造零件編號 Olsson Block JET RSB Nozzle 0.6mm
  • 製造商 Ultimaker
產品概覽和技術數據資料表
法例與合規
不適用
COO (Country of Origin): NL
產品詳細資訊

Ultimaker 2 Jet Nozzles

The Olsson block brass Jet nozzles have a special tip angle and shoulder width, they also have a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them slip more. You can print 3°C to 5°C lower because of this treatment, and is also useful for oozing and drips.

With these special nozzles, you can print faster, the plastic flows much more easier than in classic nozzles. You can also clean them efficiently with cold pulls (or atomic pulls). The geometry of the inside makes it easier to get rid of plastic so changing colours or filament type is done faster and safer.

Use the 0.25mm brass nozzle to print small detailed prints, it's an expert nozzle (RS 110-1982)
The 0.4mm (RS 110-1983) is the standard size for a lot of 3D printers
If you print in wood filaments, this brass nozzle of 0.8mm is perfect for the job (RS 110-1985)

Note

This nozzle is compatible with M6 Threads, you can put it on the Ultimaker Original (the fan shroud must be modified) or any of the Ultimaker family that has the Olsson Block mounted.

Ultimaker Accessories

規格
Attribute Value
Product Type Nozzle
Nozzle Material Brass
For Use With Olsson Block
Nozzle Size 0.6mm
17 現貨庫存,可於3工作日發貨。
單價 個
HK$ 301.75
(不含稅)
單位
Per unit
1 +
HK$301.75