Ultimaker Nozzle for use with Olsson Block 0.5mm

  • RS庫存編號 110-1986
  • 製造零件編號 Olsson Block JET RSB Steel Nozzle 0.5mm
  • 製造商 Ultimaker
產品概覽和技術數據資料表
法例與合規
不適用
COO (Country of Origin): NL
產品詳細資訊

Ultimaker 2 Jet Nozzle - Stainless Steel

The Olsson block Stainless Steel Jet nozzle has a special tip angle and shoulder width, it also has a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them slip more. You can print 3°C to 5°C lower because of this treatment, and is also useful for oozing and drips.

With this special stainless steel nozzle, you can print faster, the plastic flows much more easier than in classic nozzles. You can also clean it efficiently with cold pulls (or atomic pulls). The geometry of the inside makes it easier to get rid of plastic so changing colours or filament type is done faster and safer

If you print with abbrasive material like Carbon filled filament or Glowfill, this is the nozzle to have! Stainless steel is much stronger, it will wear down much slower than classic brass nozzles which can wear out during one long print! Only thing to remember is to print a little slower because of the difference in conductivity between stainless steel and brass

Note

This nozzle is compatible with M6 Threads, you can put it on the Ultimaker Original (the fan shroud must be modified) or any of the Ultimaker family that has the Olsson Block mounted.

Ultimaker Accessories

規格
Attribute Value
Product Type Nozzle
For Use With Olsson Block
Nozzle Material Stainless Steel
Nozzle Size 0.5mm
7 現貨庫存,可於3工作日發貨。
單價 個
HK$ 422.45
(不含稅)
單位
Per unit
1 +
HK$422.45