The CleO50 graphics display panel allows easy development of Human-Machine Interfaces (HMI) based on an Arduino-format platform. Designed to work with an Arduino UNO R3 or compatible host processor board such as the NerO available from FTDI Chip.
5.0in 800 x 480pixel TFT LCD panel with resistive touchscreen Landscape and portrait modes supported Anti-Aliased graphics throughout for much finer image quality Smooth animations at up to 60fps Direct file transfers between microSD/eFlash and Graphics subsystem without using Host processor resources FT812 Embedded Video Engine (EVE) graphic controller FT900 32-bit microcontroller MicroSD card socket 8MB eFlash memory Real-Time Clock with battery back-up USB DFU port for firmware updates Camera interface via 24-pin 0.5mm pitch FFC/FPC, bottom-contact connector Support for OmniVision OV2640 camera module or CleO-CAM1A camera PWM audio supported with speaker amplifier I²S and CAN bus interfaces Headers for 2 x MikroBUS modules CR1220 coin cell holder for battery back-up Ready to use in a panel mountable bezel Operating temperature range: -20 to +70°C
