Megger 1007-157 Insulation Tester Probe, For Use With MIT480

Telecommunication insulation and continuity testers developed to meet the special requirements of telephone line testing, as well as the requirements of electrical contractors and industrial testing to CATIV 600V. All instruments meet TNV3 as well as IEC1010, HD384 and BSEN61557. The insulation test inhibit voltage has been raised to 75V to overcome interference between cables experienced at lower voltages, compared to 50V for standard cable testing.

All models:
Complies with EN 61010-1 CATIV 600V safety rating
200mA & 20mA Continuity testing
Insulation test voltage display
75V test inhibit
TRMS and DC Voltage measurement
Dual Digital Display and Analogue bar-graph
Alkaline or NiMH rechargeable battery operation
IP54 weatherproof housing
Test lock allows the insulation test to be held on indefinitely
MIT480 specific features
50V & 100V insulation testing
100Gohms insulation range

MIT481 additional features
50V, 100V, 250V, 500V, 1000V insulation tests
200Gohms insulation range
Leakage current display
kΩ resistance measurement
Timer, PI and DAR insulation tests
Insulation limit alarms
0.1nF to 10uF Capacitance measurement
Cable length calculated from an adjustable cable capacitance reference (default 50nF/km).
Test result storage (>1000)
MIT485 additional features
Result download
Bluetooth capability (requires Bluetooth enabled PC or USB plus Bluetooth adaptor)

Hard carry case, rubber boot with stand, silicone test lead set, SP5 remote switch probe, 5 off AA alkaline batteries & instructions (CD-ROM).

Carrying out electrical checks is a cinch with this insulation tester probe from Megger. Its three-pin socket makes it straightforward to plug it into your testing instrument. A probe on its other end has a banana-style tip for reaching into terminals and test sockets to give reliable contact. It also teams up well with crocodile clips for versatility. A guard keeps your fingers away from the tip and contact points, and a cover shrouds the probe point to increase safety during tricky tests. A button on the device enables remote, one-handed operation, giving you greater flexibility when monitoring your components.

• Lead length of 1.5m for a good reach between devices
• Red lead insulated with silicone for enhanced electrical safety
• Voltage rating of 600V for use in heavy-duty electrical systems

• Aerospace and defence systems
• Electronics
• Panel building
• Industrial automation

This tester probe lead works with Megger's MFT and MIT series instruments, such as the MIT400 (921-4517) and MIT485 (122-6809) insulation testers.