Microchip, 16bit 16 bit CPU, PIC24FJ1024GA610 Microcontroller, 32MHz, 1024 kB Flash, 64-Pin TQFP

The Microchip PIC24FJ1024GB606 microcontroller has C compiler optimized instruction Set architecture with large, dual partition flash program memory and USB On-The-Go (OTG). It includes up to 1MB of Flash memory with Error Correction Code (ECC) ,32 KB of RAM and USB connectivity. It operates on 2V to 3.6V voltage range. This device also features dual-partition Flash with Live Update capability, enabling them to hold two independent software applications, permitting simultaneous programming of one partition while executing application code from the other. It has 1024 flash program memory and 32K.data memory.

Up to 16 MIPS Operation @ 32 MHz
Two Address Generation Units for Separate Read and Write Addressing of Data Memory
10,000 Erase/Write Cycle Endurance, Typical
Data Retention of 20 Years Minimum
Self-Programmable under Software Control
On-Chip Voltage Regulators (1.8V) for Low-Power Operation
Programmable Reference Clock Output
In-Circuit Serial Programming™ (ICSP™) and In-Circuit Emulation (ICE) via Two Pins
JTAG Boundary Scan Support
Detects clock failure and switches to on-chip, low-power RC Oscillator
Power-on Reset (POR), Brown-out Reset (BOR), Power-up Timer (PWRT) and Oscillator Start-up Timer (OST)
Programmable High/Low-Voltage Detect (HLVD)
Flexible Watchdog Timer (WDT) with its Own RC Oscillator for Reliable Operation
Sleep and Idle modes Selectively Shut Down
Peripherals and/or Core for Substantial Power
Reduction and Fast Wake-up
Doze mode Allows CPU to Run at a Lower Clock Speed than Peripherals
Alternate Clock modes Allow On-the-Fly Switching to a Lower Clock Speed for Selective Power Reduction
Wide Range Digitally Controlled Oscillator (DCO) for Fast Start-up and Low-Power Operation
USB v2.0 On-The-Go (OTG) Compliant
Dual Role Capable – Can Act as Either Host or Peripheral
Low-Speed (1.5 Mb/s) and Full-Speed (12 Mb/s)
USB Operation in Host mode
Full-Speed USB Operation in Device mode
High-Precision PLL for USB
USB Device mode Operation from FRC Oscillator – No Crystal Oscillator Required
Temperature range between 40°C to +85°C
TQFP (Plastic Thin Quad Flatpack) package