Electromen - EM-241PLI DC MOTOR POSITION CONTROLLER, 12-24 V DC, 15 A

The EM-241-PLI is a full bridge brushed DC-motor starter.It is designed to work in a wide range of applications and offers a host of adjustments to optimise control for each application.The drive has adjustable acceleration and deceleration ramps to produce smooth starts and stops,adjustable current limit protects motor against overcurrent and can also be used to provide an end-stop on current trip

The PLI version has a PULSE COUNTER which can be used to define end stops - the count setting is stored in non-volatile memory

This device has also two settable speeds, which are useful in positioning applications

Control inputs are present for basic forward, backward and stop commands, as well as limit switch inputs to define end stops

This device has also two settable speeds, this can be activated by dedicated input. The same input can be used for analogue speed control signal 0-5V

Fault output can indicate current trip, over-current or zero-current conditions. It can also be pulled down to ground to disable the drive, if required

C-version includes wo new parameter: freewheel options for release the rotor of motor, selectable pwm frequency (16kHz pwm being inaudible though current handling capacity is reduced)

There are two selectable control modes, in continuous mode the motor runs as long as the control is active, in impulse mode it will operate from a momentary command

Special settings are also available for start-up kick and auto reverse

For parameters setting there are 3 options: EM-236 interface unit, EM-268 with Menthol-Lite PC-program and EM-326 with Menthol-App application for smartphone;Small size with high current output

2ch pulse counter inputs

Pulse counter limits.

Current limit 0.1-20A (30A at start up)

Zero current limit

Overvoltage brake

Speed setting

Flexible control inputs

impulse / continuous mode

DIN rail mountable

Programmable parameters to suit application

* Continuous current output when ambient temp is <50°C )

15A at 100% speed / 10A at 5-99% speed pwm=2kHz

Peak ( 5s.) 30A at 2khz PWM

選取全部	屬性	值
	品牌	Electromen OY
	Product Type	DC Motor Controller
	Control Function	PWM
	Output Voltage	35 V
	Supply Voltage	10/35 V
	Current Rating	15 A
	Overall Length	42mm
	Overall Width	72mm
	Overall Depth	25 mm
	Minimum Operating Temperature	-40°C
	Maximum Operating Temperature	60°C
	Standards/Approvals	EN - 55022B

	選取全部
	品牌 Electromen OY
	Product Type DC Motor Controller
	Control Function PWM
	Output Voltage 35 V
	Supply Voltage 10/35 V
	Current Rating 15 A
	Overall Length 42mm
	Overall Width 72mm
	Overall Depth 25 mm
	Minimum Operating Temperature -40°C
	Maximum Operating Temperature 60°C
	Standards/Approvals EN - 55022B

Electromen OY DC Motor Controller, 10/35 V, 15 A, PWM Function

訂單超過 HK$250.00 免費送貨

Electromen - EM-241PLI DC MOTOR POSITION CONTROLLER, 12-24 V DC, 15 A

相关链接